TT40 Console

$789.00 ea

The TT40 Console will control up to 20 Tanning beds with a digital display always visible for every room at the front desk. With the addition of a TT40 expansion unit, the TT40 will control up to 40 beds. The TT40 operates on a low voltage 4 COM modified daisy chain hook up system which provides superior down time protection than a standard daisy chain system. The TT40 Console includes the following features; Prestart Delay, Bulb Life Meter, Clean Room Indicator, Computer Only Lockout, Session Meters and Session Limit, Can operate as a standalone or is compatible with most standard Salon Software packages. Order one Room Unit for each tanning unit to be connected to the TT40.

Includes; One each TT-40 Console Timer, One UL listed power supply, One computer interface cable, Limited Lifetime Warranty.

TT40 Exp

$749.95 ea

The TT40 EXP attaches to the TT40 and expands capacity up to 40 tanning beds. A digital display is provided for each tanning bed, 21 through 40. Order one Room Unit for each tanning unit to be connected to the TT40.

Includes; One each TT40-EXPConsole Expansion unit, Side rails and screws for interconnecting to the TT40, One UL listed power supply, and a Limited Lifetime Warranty.

RU-DS

$124.95

The RU-DS room unit with display will control one bed and has a digital display, Set Time and Start/Stop button. No 110 volt power outlet is required in the room when connected to a TT40 Console . The RU-DS is for use with a TanTime™ Systtem™ front room controller (TT-40™). This unit may also be used with a T-Max® Manager or equivalent using a SY-PAM™ adapter module for each 10 RU-DS units. The RU-DS may also be used as a backup inroom / local area stand-alone timer . Stand-alone timer function can only be accessed with a managers code. Mounts in a standard 2 gang junction box.
If using with a T-Max® Manager, and less than 3 units are being added, the RU-XM™ unit is suggested.

Includes; One RU-DS room unit, One 50' length of hookup wire, 4 mounting screws, Limited Lifetime Warranty.

RU-XM

$129.95

The RU-XM room unit with display will control one bed and has a digital display, Set Time and Start/Stop button. The RU-XM is designed for use with a T-Max® Manager or equivalent. It is intended as a cost effective alternative to the T-Max® 3A® timer. This timer emulates all the major functions of a 3A® timer and connects directly to T-Max® hookup wire. The RU-XM comes with it's own power supply.

The RU-XM may also be used as a backup inroom / local area stand-alone timer . Stand-alone timer function can only be accessed with a managers code. Mounts in a standard 2 gang junction box.

Includes; One RU-XM room unit, One 50' length of hookup wire, 4 mounting screws, one UL listed power supply and a Limited Lifetime Warranty.

TT-10-SA Timer System

$649.00 ea

The TT-10-SA is a 10 station Sunbed timer. It will control up to 5 sun beds from a central location.
Order one HVA-3 kit for each bed you will be controlling with the TT-10-SA.


The TT-10-SA Timer System kit includes:

One TT-10-SA five station timer,
One UL listed power supply,
and a "Limited Lifetime Warranty".


Download the Manual Here


*Note Sunbed must use an internal contactor. Maximum ratings, 5 Amps@220 VAC.
**This product is warranted to be free of manufacturing defects for the lifetime of the product.

SY-TT-1 Timer

$224.95

The SY-TT-1 is a local area, digital Timer that will control one Sunbed. This full featured timer can be set with a start delay between 0 and 10 minutes. A bulb life timer is also included along with a "Clean Bed" indication. These functions may be set or cleared as needed.

The SY-TT-1 may also be used with a TanTime™ Systtem™ front room controller (TT-40™), or be used with a T-Max® Manager or equivalent using a SY-PAM™ adapter module for each 5 SY-TT-1 units.

The SY-TT-1 Timer System kit includes:

One SY-TT-1 single station timer,
One UL listed power supply with plug,

One HVA-3 inroom remote control,
One 100 foot length of hookup wire,
and a "Limited Lifetime Warranty".

Download the Quickstart Instructions (pdf 135kb)


*Note Sunbed must use an internal contactor. Maximum ratings, 5 Amps@220 VAC.
**This product is warranted to be free of manufacturing defects for the lifetime of the product.

HVA-3

$74.95 ea

The HVA-3 provides inroom control for the tanning bed. Measuring approximately 2 1/2" x 3" x 1 5/8", the HVA-3 is typically located out of the way, behind the tanning bed or on top of the tanning booth.

The HVA-3 kit includes:

One HVA-3 inroom remote control,
One 100 foot length of hookup wire,
One remote Start/Stop Switch on 10' of wire,

and a "Limited Lifetime Warranty".

*Note Sunbed must use an internal contactor. Maximum ratings, 5 Amps@220 VAC.
**This product is warranted to be free of manufacturing defects for the lifetime of the product.

Accessories

SY-PTW

$34.95

Systtem™ Power Through Wire adapter, used to connect 4-wire RU-XM timers or T-Max® 3-A® timers to CAT-5 salon cabling.

Includes: One SY-PTW, one 50 foot length of Cat-5 Cable, Limited Lifetime Warranty.

Wall Bracket

$27.00

Desk Stand

$50.00

TT40 Timer Desk Stand
The TT40 mounts directly on this desk stand allowing optimum viewing angle when the TT40 Console is sitting on a computer or desk top.


Includes; One desk stand, Limited Lifetime Warranty.

TT40 Timer Wall Mounting Bracket
The TT40 mounts directly onto this wall mounting bracket. The bracket design allows for routing wires behind the TT40 and out through sheet rock if desired.


Includes; One Wall Mounting Bracket and mounting screws, Limited Lifetime Warranty.

SY-EOL

$34.95

End of Line Terminator for a CAT-5 cable, Daisy Chain installation. One EOL is required for each CAT-5 Daisy Chain of Timers. Not for use with RU-XM Room Units.

Includes: One SY-EOL, Limited Lifetime Warranty.

SY-PAM

$44.95

Systtem™ Power Adapter Module, used to interface between 4 wire T-Max® Manager installations and the CAT-5 required by RU-DS™ timers running in Emulation mode.
(Note: If you are using other TanTime™ timers running in Emulation mode, NOT RU-DS™, you do not need the power adapter. Use the SY-EMA™.)

Includes: One 3 foot long 4-wire flat cable, one 3 foot long CAT-5 cable, 1 SY-PAM Module, One UL listed power supply, & a Limited Lifetime Warranty.

SY-MAK

$29.95

The Systtem™ Multi-Mode Adapter Kit is used to interface between T-Max® Manager installations and CAT-5 TanTime™ timers running in Emulation mode.
(Note: This device does not provide power to the CAT-5 required by RU-DS™ timers. To use RU-DS timers with a T-Max® Manager use the SY-PAM™.)

Includes: One 50 foot long 4-wire flat cable with a 4-contact modular plug at each end, one 4-contact modular jack to CAT-5 jack adapter, one 10 foot long Cat-5 cable & a Limited Lifetime Warranty.

SY-TPI

$14.95

The Systtem™ Third Party Interface Cable will connect an OEM Timer to another controlling timer connected to a front room controller other than a TT-40 or a T-Max®

 

 

Includes: One 10 foot long flat adapter cable & a Limited Lifetime Warranty.

Room Unit Display

-- Free? --

The Room Unit Display shows off our industry wide compatible room units. And just like a picture tells a thousand words, a working demonstration says even that much more. Shown on the left is the RU-XM with 4-wire, telephone style connections and a wall-mount power supply. On the right is the RU-DS which works with both TanTime™ and T-Max® controllers . The RU-DS does not require an in-room AC power outlet and uses standard CAT-5 interconnect cabling, the same wires used for computer networks.

Along with the clear display fixture, the RU-Display Kit includes:

One RU-XM timer
with 4-wire, telephone style connections,
One RU-DS timer with 8-wire, Cat-5 compatible connections,
One Systtem Power Adaptor Module (SY-PAM),
One End of Line Terminator (SY-EOL),

Two UL listed power supplies,
One 10 foot 4-wire interface cable,
One set of product documentation.

*Note Sunbed must use an internal contactor. Maximum ratings, 5 Amps@220 VAC.
**This product is warranted to be free of manufacturing defects for the lifetime of the product.

The TanTime™ Logo and Systtem™ name and Logo are trademarks of EPaD™.
T-Max® and 3A® are registered trademarks of Applied Digital, Inc. (ADI) and
are in no way associated with TanTime™ or EPaD™.